Replace the fuse.
The fuse is next to the battery, and the fuse of the same specification should be replaced when replacing it. If the fuse is often burned out, the general short circuit or the load is too large, please check the electromagnetic clutch accessories.
The use of safety tubes that do not meet the specifications will bring serious consequences to the circuit system and even fire. When checking and replacing the fuse, the ignition switch should be transferred to the off position to prevent short circuit.
Adjust the direction of the headlamp.
Insert the screwdriver into the small hole in the rear panel of the front lampshade and adjust the headlight adjustment screw.
Turn the adjusting screw lamp clockwise, turn the adjusting screw counterclockwise, turn the adjusting screw lower.
The running-in mileage of the new motorcycle is 1000KM, which should be run in accordance with the requirements of the manual to extend its service life, the specific practice is as follows:
One is to control the speed of the car;
To control the load, the load should be controlled below 2/3 of the load;
Control the driving time, every 0.5 hours after driving, the engine should be turned off to cool for 10 minutes;
Change the oil frequently, it is recommended to change the oil every 300KM during running-in.
Check and adjust throttle operating parts.
1. Check and maintain the throttle handle to ensure that it is properly returned. If there is a blockage or no return, maintenance should be performed.
Remove the mirror;
2. Remove the oiler base, throttle control line and oiler;
Add a small amount of lubricating oil to the throttle control line and apply a small amount of grease to the oiler;
3. According to the order of loading can be noted: the valve line should be cleaned and lubricated once every 2000KM.